Wall Mounted Swimming Pool Lights Installation Instructions:
一The light must be installed on a flat surface of the pool. Place the mounting plate on the concrete wall and tighten it with 4 screws. The conduit must be put next to the mounting plate.( See Figure 1)
一Reserve at least 1 50mm of cable to coil around the back of the light. This 1 50mm of cable allows the light to be serviced after the pool is filled with water.
一Feed cable through the conduit to the junction box or low voltage transformer.
一The TOP sign on the light should be lined up with 12 o’clock position. If there’s not a TOP sign,the screw hole on the face ring of the light should be lined up with 12 o’clock position. ( See Figure 2)
Hang the light onto the mounting plate and tighten the pilot screw. ( See Figure 3)
Wall Mounted Swimming Pool Lights Installation Guide:
Wall Mounted Swimming Pool Lights Installation Note:
– Please calculate the transformer watts according to numbers of lamps.
– If you need play 20pcs light for same steps,please calculate as 7.5Wx20pcsx1.3=195W.You need 200-250W AC Transformer for ftting it.
– Working in 12V AC.
– Transformer and RF controller should be controlled in 10m distance from lamps.If distance is far away from lights,you need add power supply and RF controller watts.
Wall Mounted Swimming Pool Lights Installation Instructions and Guide
